Cambridge Sensors microdot Especificaciones descargar pdf (Pagina 15)

OR you can leave a drop hanging at

the tip. When the drop of blood

symbol flashes, hold the drop close

to the edge of the test strip and allow

the sample to wick automatically into

the test zone. When the test zone is

full, the meter will beep (if enabled)

and then count down in seconds 10,

9, 8…2, 1 on the display.

STEP 3

Read Result

After 10 seconds, the meter will beep

again (if enabled) and display the

test result. Compare the result with

the ranges of expected results

shown on the test strip vial.

STEP 4

Mark Result

The result can be marked as Control

Solution-Result “C” by pressing the

C Button 2 times. Pressing the C

Button a third time will remove the

marking. Marked control solution

tests will not be included in your

14-day average.

11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Comentarios a estos manuales

Sin comentarios